C613-50100-01 REV C Command Reference for x930 Series 145
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
MOVE
DEBUG
move debug
Overview This command moves a specified debug file to a destination debug file.
Syntax
move debug {<destination-name>|debug|flash|nvs|usb}
Mode Privileged Exec
Example To move debug output onto a USB storage device with a filename “my-debug”, use
the following command:
awplus# move debug usb:my-debug
Output Figure 2-5: CLI prompt after entering the move debug command
Related
Commands
copy debug
delete debug
Parameter Description
<destination-name> The filename and path where you would like the debug
output moved to. See Introduction on page 114 for valid
syntax.
Enter source file name []:
To Next Page
Loading...
