C613-50100-01 REV C Command Reference for x930 Series 2035
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
QOS COMMANDS
SHOW
MLS QOS INTERFACE QUEUE-COUNTERS
show mls qos interface queue-counters
Overview This command displays an interface’s egress queue counters. This can either be for
a specific queue or for all queues on the interface. If no queue is specified all queue
counters on the interface will be displayed.
The counters show the number of frames currently in the queue and the maximum
number of frames allowed in the queue, for individual egress queues and the port’s
queue (which will be a sum of all egress queues).
Syntax
show mls qos interface <port> queue-counters [queue <number>]
Mode User Exec and Privileged Exec
Example To show the counters for all queues on port1.0.1, use the command:
awplus# show mls qos interface port1.0.1 queue-counters
Output Figure 41-6: Example output from the show mls qos interface queue-counters
command
Parameter Description
<port> Switch port.
queue <number> Queue number, from 0 to 7.
Interface port1.0.1 Queue Counters:
Port queue length 19
Egress Queue length:
Queue 0 0
Queue 1 0
Queue 2 19
Queue 3 0
Queue 4 0
Queue 5 0
Queue 6 0
Queue 7 0
Table 43: Parameters in the output of the show mls qos interface
queue-counters command
Parameter Description
Interface Port we are showing the counters for.
To Next Page
Loading...
Need help?
General
