C613-50100-01 REV C Command Reference for x930 Series 2897
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP COMMANDS
LOCATION
CIVIC-LOCATION IDENTIFIER
location civic-location identifier
Overview Use this command to enter the Civic Address Location Configuration mode to
configure the specified location.
Use the no variant of this command to delete a civic address location. This also
removes the location from any ports it has been assigned to.
Syntax
location civic-location identifier <civic-loc-id>
no location civic-location identifier <civic-loc-id>
Default By default there are no civic address locations.
Mode Global Configuration
Usage To configure the location information for this civic address location identifier, use
the location civic-location configuration command. To associate this civic location
identifier with particular ports, use the location elin-location-id command.
Up to 400 locations can be configured on the switch for each type of location
information, up to a total of 1200 locations.
Examples To enter Civic Address Location Configuration mode for the civic address location
with ID 1, use the commands:
awplus# configure terminal
awplus(config)# location civic-location identifier 1
awplus(config-civic)#
To delete the civic address location with ID 1, use the commands:
awplus# configure terminal
awplus(config)# no location civic-location identifier 1
Related
Commands
location civic-location-id
location civic-location configuration
show location
show running-config lldp
Parameter Description
<civic-loc-id> A unique civic address location ID, in the range 1 to 4095.
To Next Page
Loading...
Need help?
General
