C613-50100-01 REV C Command Reference for x930 Series 135
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
FILE AND CONFIGURATION MANAGEMENT COMMANDS
DELETE
DEBUG
delete debug
Overview Use this command to delete a specified debug output file.
Syntax
delete debug <source-name>
Mode Privileged Exec
Example To delete debug output, use the following command:
awplus# delete debug
Output Figure 2-3: CLI prompt after entering the delete debug command
Related
Commands
copy debug
move debug
Parameter Description
<source-name> The filename and path where the debug output originates.
See Introduction on page 114 for valid URL syntax.
Enter source file name []:
To Next Page
Loading...
Need help?
General
