Allied Telesis AlliedWare Plus - Clear Test Interface

C613-50100-01 REV C Command Reference for x930 Series 438
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
INTERFACE TESTING COMMANDS
CLEAR
TEST INTERFACE
clear test interface
Overview This command clears test results and counters after issuing a test interface
command. Test results and counters must be cleared to issue subsequent test
interface commands later on.
Syntax
clear test interface {<port-list>|all}
Mode Privileged Exec
Examples To clear the counters for port1.0.1 use the command:
awplus# clear test interface port1.0.1
To clear the counters for all interfaces use the command:
awplus# clear test interface all
Related
Commands
test interface
Parameter Description
<port-list> The ports to test. A port-list can be:
• a switch port (e.g. port1.0.6)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-port1.0.6
• a comma-separated list of the above, e.g.
port1.0.1,port1.0.5-1.0.6
The specified ports must exist.
all All interfaces