C613-50100-01 REV C Command Reference for x930 Series 3071
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SFLOW COMMANDS
SFLOW
ENABLE
sflow enable
Overview This command enables sFlow® globally on the switch.
The no variant of this command disables sFlow globally on the switch.
Note that enabling sFlow does not automatically set its operational status to
active. To activate sFlow the following conditions need to be met:
•sFlow is enabled.
• The sFlow agent address is set.
• The sFlow collector address is set to a valid (non zero) IPv4 or IPv6 address.
• Polling or sampling is enabled on the ports to be sampled or polled.
Syntax
sflow enable
no sflow enable
Default sFlow is disabled globally on the switch.
Mode Global Configuration
Example To enable sFlow operation, use the command:
awplus# configure terminal
awplus(config)# sflow enable
Related
Commands
show running-config sflow
show sflow
To Next Page
Loading...
Need help?
General
