C613-50100-01 REV C Command Reference for x930 Series 3017
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
TRIGGER COMMANDS
TIME
(TRIGGER)
time (trigger)
Overview This command specifies the time of day when the trigger is permitted to activate.
The after parameter specifies the start of a time period that extends to midnight
during which trigger may activate. By default the value of this parameter is
00:00:00 (am); that is, the trigger may activate at any time. The before parameter
specifies the end of a time period beginning at midnight during which the trigger
may activate. By default the value of this parameter is 23:59:59; that is, the trigger
may activate at any time. If the value specified for before is later than the value
specified for after, a time period from “ after ” to “ before ” is defined, during which
the trigger may activate. This command is not applicable to time triggers ( type
time).
The following figure illustrates how the before and after parameters operate.
Syntax
time {[after <hh:mm:ss>] [before <hh:mm:ss>]}
Mode Trigger Configuration
ää\ää äÈ\ää £Ó\ää £n\ää ää\ää
ää\ää äÈ\ää £Ó\ää £n\ää ää\ää
ää\ää äÈ\ää £Ó\ää £n\ää ää\ää
ää\ää äÈ\ää £Ó\ää £n\ää ää\ää
"%&/2%
!&4%2
!&4%2"%&/2%
!&4%2"%&/2%
*iÀ`ÊÜiÊÌÀ}}iÀÊ>ÞÊ>VÌÛ>Ìi°iÞ\
*iÀ`ÊÜiÊÌÀ}}iÀÊ>ÞÊÌÊ>VÌÛ>Ìi°
/,ÚäÓ
Parameter Description
after<hh:mm:ss> The earliest time of day when the trigger may be activated.
before<hh:mm:ss> The latest time of day when the trigger may be activated.
To Next Page
Loading...
Need help?
General
