C613-50100-01 REV C Command Reference for x930 Series 2443
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
SHOW
STACK DETAIL
Virtual MAC
Address
The Virtual MAC address of the stack.
Disabled Master
Monitoring
The current Disabled Master Monitoring status. This can be:
• Enabled
• Disabled
• Inactive
Operational
Status
The status of the stack. This can be:
• Normal operation:
If any other status is displayed, it may warrant further
investigation.
• Stacking hardware disabled:
Use the stack enable command to activate the stacking
feature.
• Operating in failover mode:
This stack member has become separated from the rest of
the stack, or it failed to join the stack correctly.
• Standalone unit:
Stacking is enabled, but no other stack members are present.
• Not all stack ports are up:
One or more stacking ports may be down, or stacking
discovery may not have detected the neighbor successfully.
Stack Status The stack’s overall status. Note that a warning is issued if the
stack is not connected in a standard ring topology.
Pending ID The pending stack member ID. This can be changed by the
stack renumber command. If there is no pending ID, the “-”
symbol will display.
Stack port
status
The status of the stack port. This can be:
• Down
• Neighbor incompatible
• Discovering neighbor
• Learned neighbor
Priority Stack member master election priority (between 1 and 255)
Note that the lowest number has the highest priority.
Product Type The switch series that the stack member belongs to.
Provisioned Indicates that the stack position is provisionally configured,
i.e. ready to accept a particular switch type into the stack.
Table 4: Parameters in the output from the show stack detail command (cont.)
Parameter Description