C613-50100-01 REV C Command Reference for x930 Series 2624
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF AREA GUESTS
show atmf area guests
Overview This command will display details of all guests that the controller is aware of.
Syntax
show atmf area guests [<area-name> [<node-name>]]
Default N/A
Mode User Exec/Privileged Exec
Example 1 To display atmf area guest nodes on a controller, use the command,
GuestNode[1]#show atmf area guests
Output Figure 54-8: Example output from the show atmf area guests command
Parameter Description
<area-name> The area name for guest information
<node-name> The name of the node that connects to the guests.
main-building Area Guest Node Information:
Device MAC IP/IPv6
Type Address Parent Port Address
------------------------------------------------------------------------------
- 0008.5d10.7635 x230 1.0.3 192.168.5.4
AT-TQ4600 eccd.6df2.da60 wireless-node1 1.0.4 192.168.5.3
- 0800.239e.f1fe x230 1.0.4 192.168.4.8
AT-TQ4600 001a.eb3b.dc80 wireless-node2 1.0.7 192.168.4.12
main-building guest node count 4
GuestNode[1]#
Table 9: Parameters in the output from show atmf area guests command
Parameter Description
Device Type The device type as read from the guest node.
MAC Address The MAC address of the guest-node
Parent The device that directly connects to the guest-node
Port The port number on the parent node that connects to the guest
node.
IP/IPv6 The IP or IPv6 address of the guest node.
To Next Page
Loading...
Need help?
General
