Allied Telesis AlliedWare Plus - Chapter 6: GUI Commands; GUI Commands; Introduction

6
C613-50100-01 REV C Command Reference for x930 Series 220
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
GUI Commands
Introduction
Overview This chapter provides an alphabetical reference of commands used to configure
the GUI. For more information, see the Getting Started with Alliedware Plus
Command List •“atmf topology-gui enable” on page 221
•“gui-timeout” on page 222
•“log event-host” on page 224
•“service http” on page 225
•“show http” on page 226