C613-50100-01 REV C Command Reference for x930 Series 2460
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
STACK
VIRTUAL-MAC
stack virtual-mac
Overview This command enables the stack virtual MAC address feature. For more
information on this topic, see the VCStack Feature Overview and Configuration
Guide. With this command set, the value applied for the virtual MAC address is
determined by the setting of the command stack virtual-chassis-id.
CAUTION: Stack operation is only supported ifstack virtual-macis enabled.
Before enabling the virtual MAC address feature, you should check that the stack’s
virtual-chassis-id is not already used by another stack in the network. Otherwise the
duplicate MAC addresses will cause problems for the network traffic.
Syntax
stack virtual-mac
no stack virtual mac
Mode Global Configuration
Usage Note that this command will not take effect until the switch has been rebooted.
Example
awplus# configure terminal
awplus(config)# stack virtual mac
Related
Commands
show running-config
show stack
switch provision (stack)
stack virtual-chassis-id
To Next Page
Loading...
Need help?
General
