49
C613-50100-01 REV C Command Reference for x930 Series 2357
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DHCP Snooping
Commands
Introduction
Overview This chapter gives detailed information about the commands used to configure
DHCP snooping. For detailed descriptions of related ACL commands, see IPv4
Hardware Access Control List (ACL) Commands. For more information about DHCP
snooping, see the DHCP Snooping Feature Overview and Configuration Guide.
DHCP snooping can operate on static link aggregators (e.g. sa2) and dynamic link
aggregators (e.g. po2), as well as on switch ports (e.g. port1.0.2).
Command List •“arp security” on page 2359
•“arp security violation” on page 2360
•“clear arp security statistics” on page 2362
•“clear ip dhcp snooping binding” on page 2363
•“clear ip dhcp snooping statistics” on page 2364
•“debug arp security” on page 2365
•“debug ip dhcp snooping” on page 2366
•“ip dhcp snooping” on page 2367
•“ip dhcp snooping agent-option” on page 2368
•“ip dhcp snooping agent-option allow-untrusted” on page 2369
•“ip dhcp snooping agent-option circuit-id vlantriplet” on page 2370
•“ip dhcp snooping agent-option remote-id” on page 2371
•“ip dhcp snooping binding” on page 2372
•“ip dhcp snooping database” on page 2373
•“ip dhcp snooping delete-by-client” on page 2374
•“ip dhcp snooping delete-by-linkdown” on page 2375
•“ip dhcp snooping max-bindings” on page 2376