EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2461 background imageLoading...
Page #2461 background image
C613-50100-01 REV C Command Reference for x930 Series 2461
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VIRTUAL CHASSIS STACKING (VCSTACK™) COMMANDS
SWITCH
PROVISION (STACK)
switch provision (stack)
Overview This command enables you to provide the configuration for a new stack member
switch prior to physically connecting it to the stack. To run this command, the stack
position must be vacant. The selected hardware type must be compatible existing
stack hardware.
Use the no variant of this command to remove an existing switch provision.
Syntax
switch <stack-ID> provision {x930-28|x930-52}
no switch <stack-ID> provision
Mode Global Configuration
Usage
Examples To provision an x930-28 switch as stack member 3, use the following commands:
awplus# configure terminal
awplus(config)# switch 3 provision x930-28
To remove the provision of the x930-28 switch as stack member 3, use the
following commands:
awplus# configure terminal
awplus(config)# no switch 3 provision
Related
Commands
show provisioning (stack)
show stack
Parameter Description
<stack-ID> Stack member number, from 1 to 8.
provision Provides settings within the stack configuration ready for a
specific switch type to become a stack member.
x930-28 Provision a 28-port x930 switch.
x930-52 Provision a 52-port x930 switch.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals