C613-50100-01 REV C Command Reference for x930 Series 2684
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SWITCHPORT
ATMF-GUESTLINK
switchport atmf-guestlink
Overview Guest links are used to provide basic AMF functionality to non AMF capable
devices. Guest links can be configured for either a selected switch port or a range
of switch ports and use generic protocols to collect status and configuration
information that the guest devices make available.
Use the no variant of this command to remove the guest node functionality from
the selected port or ports.
Syntax
switchport atmf-guestlink [class <GUEST-CLASS>] [ip <A.B.C.D> |
ipv6 <X:X::X:X>]
no switchport atmf-guestlink
Default No guest links are configured.
Mode Interface
Example 1 To configure switch port 1.0.44 to be a guest link, that will connect to a guest node
having a guest-class of camera and an IPv4 address of 192.168.3.3, use the
following commands:
node1# configure terminal
node1(config)# int port1.0.44
node1(config-if)# switchport atmf-guestlink class camera ip
192.168.3.3
node1(config-if)# end
Example 2 To configure switchport 1.0.41 to be a guest link, that will connect to a guest node
having a guest-class of phone and an IPv6 address of 2001:db8:21e:10d::5, use
the following commands:
node1# configure terminal
node1(config)# int port1.0.41
node1(config-if)# switchport atmf-guestlink class phone ipv6
2000:db8:21e:10d::5
node1(config-if)# end
Parameter Description
class Set a Guest-class
<GUEST-CLASS> The name of the guest class.
ip Specifies that the address following will have an IPv4 format
<A.B.C.D> The Guest-node’s IP address in IPv4 format.
ipv6 Specifies that the address following will have an IPv6 format
<X:X::X:X> The Guest-node’s IP address in IPv6 format.
To Next Page
Loading...
Need help?
General
