Allied Telesis AlliedWare Plus - Page 2685

C613-50100-01 REV C Command Reference for x930 Series 2685
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SWITCHPORT
ATMF-GUESTLINK
Example 3 To configure switch port 1.0.41 to be a guest link, using the default model type and
learning method address, use the following commands:
node1# configure terminal
node1(config)# int port1.0.41
node1(config-if)# switchport atmf-guestlink
node1(config-if)# end
Example 4 To configure switch ports 1.0.52 to 1.0.54 to be guest links, for the guest class
camera, use the following commands:
node1# configure terminal
node1(config)# int port1.0.41-port1.0.44
node1(config-if)# switchport atmf-guestlink class camera
node1(config-if)# end
Example 5 To remove the guest-link functionality from switchport 1.0.41, use the following
commands:
node1# configure terminal
node1(config)# int port1.0.41
node1(config-if)# no switchport atmf-guestlink
node1(config-if)# end
Related
Commands
atmf guest-class
discovery
http-enable
username
modeltype
show atmf links guest
show atmf guest