C613-50100-01 REV C Command Reference for x930 Series 1772
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
DEBUG
IPV6 PIM SPARSE-MODE PACKET
debug ipv6 pim sparse-mode packet
Overview Use this command to activate PIM-SMv6 packet debugging.
Use the no variant of this command to deactivate PIMv6 packet debugging.
Syntax
debug ipv6 pim sparse-mode packet {in|out}
no debug ipv6 pim sparse-mode packet {in|out}
Mode Privileged Exec and Global Configuration
Example
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# debug ipv6 pim sparse-mode packet in
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# debug ipv6 pim sparse-mode packet out
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# no debug ipv6 pim sparse-mode packet in
awplus# configure terminal
awplus(config)# terminal monitor
awplus(config)# no debug ipv6 pim sparse-mode packet out
Related
commands
show debugging ipv6 pim sparse-mode
undebug all ipv6 pim sparse-mode
Parameter Description
packet Activates debug printing of incoming and/or outgoing IPv6 packets.
in Specify incoming packet debugging.
out Specify outgoing packet debugging.
To Next Page
Loading...
Need help?
General
