C613-50100-01 REV C Command Reference for x930 Series 300
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
TERMINAL
MONITOR
terminal monitor
Overview Use this command to display debugging output on a terminal.
To display the cursor after a line of debugging output, press the Enter key.
Use the command terminal no monitor to stop displaying debugging output on
the terminal, or use the timeout option to stop displaying debugging output on
the terminal after a set time.
Syntax
terminal monitor [<1-60>]
terminal no monitor
Default Disabled
Mode User Exec and Privileged Exec
Examples To display debugging output on a terminal, enter the command:
awplus# terminal monitor
To specify timeout of debugging output after 60 seconds, enter the command:
awplus# terminal monitor 60
To stop displaying debugging output on the terminal, use the command:
awplus# terminal no monitor
Related
Commands
All debug commands
Parameter Description
<1-60> Set a timeout between 1 and 60 seconds for terminal output.
To Next Page
Loading...
