C613-50100-01 REV C Command Reference for x930 Series 1793
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
IPV
6 PIM REGISTER-SOURCE
ipv6 pim register-source
Overview Use this command to configure the source IPv6 address of register packets sent by
this DR, overriding the default source IPv6 address, which is the IPv6 address of the
RPF interface toward the source host.
Use the no variant of this command to remove the IPv6 source address of Register
packets sent by this DR, reverting back to use the default IPv6 source address that
is the address of the RPF interface toward the source host.
Syntax
ipv6 pim register-source [<source-IPv6-address>|<interface>]
no ipv6 pim register-source
Usage The configured address must be a reachable address to be used by the RP to send
corresponding Register-Stop messages in response. It is normally the local
loopback IPv6 interface address, but can also be a physical IPv6 address. This IPv6
address must be advertised by unicast routing protocols on the DR. The configured
interface does not have to be PIM-SMv6 enabled.
Mode Global Configuration
Examples awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim register-source 3ffe::24:2
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# ipv6 pim register-source vlan2
awplus# configure terminal
awplus(config)# ipv6 forwarding
awplus(config)# ipv6 multicast-routing
awplus(config)# no ipv6 pim register-source
Parameter Description
<source-IPv6-
address>
The IPv6 address, entered in the form X:X::X:X, to be used as the
source of the register packets.
<interface> The name of the VLAN interface to be used as the source of the
register packets.
To Next Page
Loading...
Need help?
General
