Allied Telesis AlliedWare Plus - Show Ip Mvif

C613-50100-01 REV C Command Reference for x930 Series 1707
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
MULTICAST COMMANDS
SHOW
IP MVIF
show ip mvif
Overview Use this command to display the contents of the IPv4 Multicast Routing
Information Base (MRIB) VIF table.
Syntax
show ip mvif [<interface>]
Mode User Exec and Privileged Exec
Example
awplus# show ip mvif vlan2
Output Figure 33-6: Example output from the show ip mvif command
Figure 33-7: Example output from the show ip mvif command with the
interface parameter vlan2 specified
Parameter Description
<interface> The interface to display information about.
Interface Vif Owner TTL Local Remote Uptime
Idx Module Address Address
vlan2 0 PIM-SM 1 192.168.1.53 0.0.0.0 00:04:26
Register 1 1 192.168.1.53 0.0.0.0 00:04:26
vlan3 2 PIM-SM 1 192.168.10.53 0.0.0.0 00:04:25

Interface Vif Owner TTL Local Remote Uptime
Idx Module Address Address
vlan2 0 PIM-SM 1 192.168.1.53 0.0.0.0 00:05:17