Allied Telesis AlliedWare Plus - Ip Pim Dense-Mode

C613-50100-01 REV C Command Reference for x930 Series 1838
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-DM COMMANDS
IP
PIM DENSE-MODE
ip pim dense-mode
Overview This command enables or disables PIM-DM operation from Interface mode on the
current VLAN interface. This command also disables passive mode on the VLAN
interface if passive mode has been enabled using an ip pim dense-mode passive
command.
The no variant of this command disables all PIM-DM activities on the interface.
Syntax
ip pim dense-mode
no ip pim dense-mode
Mode Interface Configuration for a VLAN interface.
Example
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip pim dense-mode