C613-50100-01 REV C Command Reference for x930 Series 1916
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST EXTENDED TCP UDP FILTER)
(access-list extended TCP UDP filter)
Overview Use this ACL filter to add a new TCP or UDP filter entry to the current extended
access-list. If the sequence number is specified, the new filter is inserted at the
specified location. Otherwise, the new filter is added at the end of the access-list.
The no variant of this command removes a TCP or UDP filter entry from the current
extended access-list. You can specify the TCP or UDP filter entry for removal by
entering either its sequence number (e.g. no 10), or by entering its TCP or UDP
filter profile without specifying its sequence number.
Note that the sequence number can be found by running the show access-list (IPv4
Software ACLs) command.
Syntax [tcp|udp]
[<sequence-number>] {deny|permit} {tcp|udp} <source> {eq
<sourceport> |lt <sourceport>|gt <sourceport>|ne <sourceport>}
<destination> [eq <destport>|lt <destport>|gt <destport>|ne
<destport>] [log]
no [<sequence-number>]{deny|permit} {tcp|udp} <source> {eq
<sourceport> |lt <sourceport>|gt <sourceport>|ne <sourceport>}
<destination> [eq <destport>|lt <destport>|gt <destport>|ne
<destport>] [log]
no <sequence-number>
Parameter Description
<sequence-
number>
<1-65535>
The sequence number for the filter entry of the selected access
control list.
deny Access-list rejects packets that match the source and destination
filtering specified with this command.
permit Access-list permits packets that match the source and destination
filtering specified with this command.
tcp The access-list matches only TCP packets.
udp The access-list matches only UDP packets.
<source> The source address of the packets. You can specify a single host, a
subnet, or all sources. The following are the valid formats for
specifying the source:
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix length.
This matches any source IP address
within the specified subnet.
any Matches any source IP address.
<sourceport> The source port number, specified as an integer between 0 and
65535.
To Next Page
Loading...
Need help?
General
