C613-50100-01 REV C Command Reference for x930 Series 1915
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST EXTENDED IP PROTOCOL FILTER)
Example 2
[adding to a list]
Use the following commands to add a new access-list filter entry at sequence
position 5 in the access-list named my-list that will accept packets from source
address 10.10.1.1/24 to destination address 192.68.1.1/24:
awplus# configure terminal
awplus(config)# access-list extended my-list
awplus(config-ip-ext-acl)# 5 permit ip 10.10.1.1/24
192.168.1.1/ 24
To Next Page
Loading...
