C613-50100-01 REV C Command Reference for x930 Series 1811
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE INTERFACE DETAIL
show ipv6 pim sparse-mode interface detail
Overview Use this command to show detailed PIM-SMv6 information for all PIM-SMv6
configured interfaces.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 pim sparse-mode interface detail
Mode User Exec and Privileged Exec
Example To show detailed PIM-SMv6 information for all PIM-SMv6 configured interfaces,
use the command:
awplus# show ipv6 pim sparse-mode interface detail
Output Figure 35-4: Example output from the show ipv6 pim sparse-mode interface
detail command
awplus#show ipv6 pim sparse-mode interface detail
vlan2 (vif 0)
Address fe80::207:e9ff:fe02:81d, DR fe80::20e:cff:fe01:facc
Hello period 30 seconds, Next Hello in 21 seconds
Triggered Hello period 5 seconds
Secondary addresses:
3ffe:192:168:1::53
Neighbors:
fe80::202:b3ff:fed4:69fe
fe80::20e:cff:fe01:facc
vlan3 (vif 2):
Address fe80::207:e9ff:fe02:21a2, DR fe80::207:e9ff:fe02:21a2
Hello period 30 seconds, Next Hello in 20 seconds
Triggered Hello period 5 seconds
Secondary addresses:
3ffe:192:168:10::53
Neighbors:
To Next Page
Loading...
Need help?
General
