Allied Telesis AlliedWare Plus - Show Port-Security Interface

C613-50100-01 REV C Command Reference for x930 Series 496
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SWITCHING COMMANDS
SHOW
PORT-SECURITY INTERFACE
show port-security interface
Overview Use this command to show the current port-security configuration and the switch
port status.
Syntax
show port-security interface <port>
Mode Privileged Exec
Example To see the port-security status on port1.0.1, use the following command:
awplus# show port-security interface port1.0.1
Output Figure 14-9: Example output from the show port-security interface command
Related
Commands
clear port-security intrusion
show port-security intrusion
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
Parameter Description
<port> The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
Port Security configuration
Security Enabled : YES
Port Status : ENABLED
Violation Mode : TRAP
Aging : OFF
Maximum MAC Addresses : 3
Total MAC ddresses : 1
Lock Status : UNLOCKED
Security Violation Count : 0
Last Violation Source Address : None