C613-50100-01 REV C Command Reference for x930 Series 816
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV6 COMMANDS
IPV
6 ND MANAGED-CONFIG-FLAG
ipv6 nd managed-config-flag
Overview Use this command to set the managed address configuration flag, contained
within the router advertisement field.
Setting this flag indicates the operation of a stateful autoconfiguration protocol
such as DHCPv6 for address autoconfiguration, and that address information (i.e.
the network prefix) and other (non-address) information can be requested from
the device.
An unset flag enables hosts receiving the advertisements to use a stateless
autoconfiguration mechanism to establish their IPv6 addresses. The default is flag
unset.
Use the no variant of this command to reset this command to its default of, flag
unset.
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface.
Usage Advertisement flags will not be transmitted unless you have applied the ipv6 nd
suppress-ra command. This step is included in the example below.
Example To set the managed address configuration flag on the VLAN interface vlan2, use
the following commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 nd managed-config-flag
awplus(config-if)# no ipv6 nd suppress-ra
Related
Commands
ipv6 nd suppress-ra
ipv6 nd prefix
ipv6 nd other-config-flag
To Next Page
Loading...
Need help?
General
