C613-50100-01 REV C Command Reference for x930 Series 1743
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SM COMMANDS
IP
PIM SPARSE-MODE
ip pim sparse-mode
Overview Use this command to enable PIM-SM on the VLAN interface.
Use the no variant of this command to disable PIM-SM on the VLAN interface.
Syntax
ip pim sparse-mode
no ip pim sparse-mode
Mode Interface Configuration for a VLAN interface.
Examples
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip pim sparse-mode
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# no ip pim sparse-mode
To Next Page
Loading...
