C613-50100-01 REV C Command Reference for x930 Series 651
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LINK AGGREGATION COMMANDS
SHOW
ETHERCHANNEL
show etherchannel
Overview Use this command to display information about a LACP channel specified by the
channel group number.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the action parameter of the thrash-limiting command is set to
vlan-disable, the output will also show the VLANs on which thrashing is detected.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide, which is
available on our website at alliedtelesis.com.
Syntax
show etherchannel [<1-32>]
Mode User Exec and Privileged Exec
Example
awplus# show etherchannel
Output Figure 17-3: Example output from show etherchannel
Example
awplus# show etherchannel 1
Output Figure 17-4: Example output from show etherchannel for a particular channel
Parameter Description
<1-32> Channel-group number.
awplus#show etherchannel
LAG Maximum : 128
LAG Static Maximum: 96
LAG Dynamic Maximum: 32
LAG Static Count : 0
LAG Dynamic Count : 1
LAG Total Count : 1
Lacp Aggregator: po1
Member:
port1.0.5
port1.0.6
awplus#show etherchannel 1
Aggregator po1 (4601)
Mac address: 00:00:00:00:00:00
Admin Key: 0001 - Oper Key 0000
Receive link count: 0 - Transmit link count: 0
Individual: 0 - Ready: 0
Partner LAG: 0x0000,00-00-00-00-00-00
Link: port1.0.1 (5001) disabled
Link: port1.0.2 (5002) disabled
To Next Page
Loading...
Need help?
General
