C613-50100-01 REV C Command Reference for x930 Series 1541
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
VRF LITE COMMANDS
SHOW
ARP
show arp
Overview Use this command to display entries in the ARP routing and forwarding table—the
ARP cache contains mappings of IP addresses to physical addresses for hosts. To
have a dynamic entry in the ARP cache, a host must have used the ARP protocol to
access another host.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show arp [security [interface [<interface-list>]]
show arp [statistics [detail][interface [<interface-list>]]
Syntax (VRF lite) show arp [global|security|vrf <vrf-name>]
Mode User Exec and Privileged Exec
Usage Running this command with no additional parameters will display all entries in the
ARP routing and forwarding table.
With VRF lite configured, and no additional parameters entered, the command
output displays all entries, listed by their VRF lite instance. By adding either a
specific VRF lite instance or global parameter entry, you can selectively list ARP
entries by their membership of a specific VRF lite instance.
Example To display all ARP entries in the ARP cache, use the following command:
awplus# show arp
Parameter Description
security Specify the DHCP Snooping ARP security output option.
interface Specify an interface list for DHCP Snooping ARP security
output.
<interface-list> Specify a single Layer 3 interface name, or a a range of
interfaces.
statistics Specify brief DHCP Snooping ARP security statistics.
detail Specify detailed DHCP Snooping ARP security statistics.
global When VRF lite is configured, apply this command to the global
routing and forwarding table
vrf Apply this command to the specified VRF lite instance.
<vrf-name> The VRF lite instance name
To Next Page
Loading...
Need help?
General
