C613-50100-01 REV C Command Reference for x930 Series 350
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LOGGING COMMANDS
LOG
CONSOLE (FILTER)
log console (filter)
Overview This command creates a filter to select messages to be sent to all consoles when
the log console command is given. Selection can be based on the priority/severity
of the message, the program that generated the message, the logging facility
used, a sub-string within the message or a combination of some or all of these.
Syntax
log console [level <level>] [program <program-name>] [facility
<facility>] [msgtext <text-string>]
no log console [level <level>] [program <program-name>]
[facility <facility>] [msgtext <text-string>]
Parameter Description
level Filter messages by severity level.
<level> The minimum severity of message to send. The level can be specified as one of the following
numbers or level names, where 0 is the highest severity and 7 is the lowest severity:
0|emergencies System is unusable
1|alerts Action must be taken immediately
2|critical Critical conditions
3|errors Error conditions
4|warnings Warning conditions
5|notices Normal, but significant, conditions
6|informational Informational messages
7|debugging Debug-level messages
program Filter messages by program. Include messages from a specified program.
<program-
name>
The name of a program to log messages from, either one of the following predefined program
names (not case-sensitive), or another program name (case-sensitive) that you find in the log
output:
rip Routing Information Protocol (RIP)
ripng Routing Information Protocol - next generation (RIPng)
ospf Open Shortest Path First (OSPF)
ospfv3 Open Shortest Path First (OSPF) version 3 (OSPFv3)
bgp Border Gateway Protocol (BGP)
rsvp Resource Reservation Protocol (RSVP)
pim-dm Protocol Independent Multicast - Dense Mode (PIM-DM)
pim-sm Protocol Independent Multicast - Sparse Mode (PIM-SM)
pim-smv6 PIM-SM version 6 (PIM-SMv6)
dot1x IEEE 802.1X Port-Based Access Control
To Next Page
Loading...
Need help?
General
