C613-50100-01 REV C Command Reference for x930 Series 313
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PLUGGABLES AND CABLING COMMANDS
SHOW
SYSTEM FIBER-MONITORING
show system fiber-monitoring
Overview Use this command to display settings and current status for Active Fiber
Monitoring.
Syntax
show system fiber-monitoring
Mode User Exec/Privileged Exec
Example To display configuration and status for active fiber monitoring on ports, use the
command:
awplus# show system fiber-monitoring
Output Figure 8-2: Example output from show system fiber-monitoring
awplus#show sys fiber-monitoring
Fiber Monitoring Status
Reading units 0.0001mW
Stack member 1:
Interface port1.0.1
Status: enabled
Supported: Supported pluggable
Debugging: disabled
Interval: 2 seconds
Sensitivity: 1.00dB
Baseline type: average of last 35 values greater than 50
Status:
Baseline value: 496
Alarm threshold: 393
Alarm: no
Last 12 Readings: 498 498 498 498 498 498 498 498 498 498 498 498
Minimum reading: 486
Maximum reading: 498
Interface port1.0.2
Status: enabled
Supported: Supported pluggable
Debugging: disabled
Interval: 2 seconds
Sensitivity: 1.00dB
Baseline type: average of last 30 values greater than 50
Status:
Baseline value: 0
Alarm threshold: 0
Alarm: no
Last 12 Readings: 0 0 0 0 0 0 0 0 0 0 0 0
Minimum reading: 0
Maximum reading: 0
To Next Page
Loading...
Need help?
General
