C613-50100-01 REV C Command Reference for x930 Series 1439
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ROUTE MAP COMMANDS
MATCH
INTERFACE
match interface
Overview Use this command to add an interface match clause to a route map entry. Specify
the interface name to match.
A route matches the route map if its interface matches the interface name.
Each entry of a route map can only match against one interface in one interface
match clause. If the route map entry already has an interface match clause,
entering this command replaces that match clause with the new clause.
Use the no variant of this command to remove the interface match clause from the
route map entry. Use the no variant of this command without a specified interface
to remove all interfaces.
Syntax
match interface <interface>
no match interface [<interface>]
Mode Route-map Configuration
Usage This command is valid for RIP and OSPF routes only.
Example To add entry 10 to the route map called mymap1, which will process routes if they
use the interface vlan1, use the commands:
awplus# configure terminal
awplus(config)# route-map mymap1 permit 10
awplus(config-route-map)# match interface vlan1
To remove all interfaces from the route map called mymap1, use the commands:
awplus# configure terminal
awplus(config)# route-map mymap1 permit 10
awplus(config-route-map)# no match interface
Related
Commands
match ip address
match ip next-hop
match route-type
match tag
route-map
show route-map
Parameter Description
<interface> The VLAN to match, e.g. vlan2.
To Next Page
Loading...
Need help?
General
