C613-50100-01 REV C Command Reference for x930 Series 292
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM MAC
show system mac
Overview This command displays the physical MAC address available on a standalone
switch, or a stack. This command also shows the virtual MAC address for a stack if
the stack virtual MAC address feature is enabled with the stack virtual-mac or the
stack enable command.
Syntax
show system mac
Mode User Exec and Privileged Exec
Usage For more information about the virtual MAC address feature, see the VCStack
Feature Overview and Configuration Guide.
Example To display the physical MAC address enter the following command:
awplus# show system mac
Output Figure 7-21: Example output from the show system mac command
Output Figure 7-22: Example output showing how to use the stack virtual-mac
command and the show system mac command
Related
Commands
stack virtual-mac
awplus#show system mac
eccd.6d9d.4eed (system)
awplus#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#stack virtual-mac
% Please check that the new MAC 0000.cd37.0065 is unique within
the network.
% Save the config and restart the system for this change to take
effect.
Member1#copy run start
Building configuration...
[OK]
Member1#reload
reboot system? (y/n): y
... Rebooting at user request ...
Loading default configuration ....
awplus login: manager
Password:
awplus>show system mac
eccd.6d9d.4eed
Virtual MAC Address 0000.cd37.0065
To Next Page
Loading...
Need help?
General
