Allied Telesis AlliedWare Plus - Ip Igmp Snooping Report-Suppression

C613-50100-01 REV C Command Reference for x930 Series 1616
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP AND IGMP SNOOPING COMMANDS
IP
IGMP SNOOPING REPORT-SUPPRESSION
ip igmp snooping report-suppression
Overview Use this command to enable report suppression for IGMP versions 1 and 2. This
command applies to interfaces configured for IGMP Snooping.
Report suppression stops reports being sent to an upstream multicast router port
when there are already downstream ports for this group on this interface.
Use the no variant of this command to disable report suppression.
Syntax
ip igmp snooping report-suppression
no ip igmp snooping report-suppression
Default Report suppression does not apply to IGMPv3, and is turned on by default for
IGMPv1 and IGMPv2 reports.
Mode Interface Configuration for a VLAN interface.
Example To enable report suppression for IGMPv2 reports for vlan2, use the commands:
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ip igmp version 2
awplus(config-if)# ip igmp snooping report-suppression
Related
Commands
show ip igmp interface
show running-config