C613-50100-01 REV C Command Reference for x930 Series 1410
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
SHOW
IP BGP NEIGHBORS KEEPALIVE-INTERVAL (BGP ONLY)
show ip bgp neighbors keepalive-interval
(BGP only)
Overview Use this command to display the configured keepalive-interval value of the peer at
the session establishment time with the neighbor.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip bgp neighbors <ipv4-addr> keepalive-interval
Default The keepalive timer default is 60 seconds as per RFC 4271. Keepalive is holdtime / 3.
Mode User Exec and Privileged Exec
Examples
awplus# show ip bgp neighbors 10.11.4.26 keepalive-interval
Related
Commands
neighbor timers
show ip bgp neighbors hold-time (BGP only)
timers
Parameter Description
<ipv4-addr> The IPv4 address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
To Next Page
Loading...
Need help?
General
