C613-50100-01 REV C Command Reference for x930 Series 199
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
USER ACCESS COMMANDS
TELNET
SERVER
telnet server
Overview This command enables the telnet server on the specified TCP port. If the server is
already enabled then it will be restarted on the new port. Changing the port
number does not affect the port used by existing sessions.
Syntax
telnet server {<1-65535>|default}
Mode Global Configuration
Example To enable the telnet server on TCP port 2323, use the following commands:
awplus# configure terminal
awplus(config)# telnet server 2323
Related
Commands
show telnet
Parameter Description
<1-65535> The TCP port to listen on.
default Use the default TCP port number 23.
To Next Page
Loading...
Need help?
General
