C613-50100-01 REV C Command Reference for x930 Series 2647
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ALLIED TELESIS MANAGEMENT FRAMEWORK™ (AMF) COMMANDS
SHOW
ATMF GUEST
show atmf guest
Overview This command is available on any AMF master in the network. It displays details
about the AMF guest nodes that exist in the AMF network, such as device type, IP
address and MAC address etc.
Syntax
show atmf guest [<node-name>] [<guest-port>]
Mode User Exec/Privileged Exec
Example To display the ATMF guest output, use the command:
awplus# show atmf guest
Output Figure 54-11: Example output from the show atmf guest command.
Parameter Description
<node-name> The name of the guest node’s parent.
<guest-port> The port name on the parent node.
master#show atmf guests
Guest Information:
Device Device Parent Guest IP/IPv6
Name Type Node Port Address
---------------------------------------------------------------------
master-2.1.1 AR415S master 2.1.1 192.168.2.10
master-2.1.2 AT-9924T master 2.1.2 192.168.1.10
master-2.1.4 AT-TQ3200 master 2.1.4 192.168.1.12
Current ATMF guest node count 3
Table 60: Parameters shown in the output of the show atmf guest command
Parameter Description
Device Name The name that is discovered from the device, or failing
that, a name that is auto-assigned by AMF. The
auto-assigned name consists of <parent node
name>-<attached port number>
Device Type This is the product name of the Guest Node and is
discovered from the device. If no device Type can be
discovered, then the modelName configured on the
Guest-class assigned to the connected port is used.
Parent Node The AMF member name of the AMF member that directly
connects to the guest node.
To Next Page
Loading...
Need help?
General
