C613-50100-01 REV C Command Reference for x930 Series 1819
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE NEXTHOP
show ipv6 pim sparse-mode nexthop
Overview Use this command to see the next hop information as used by PIM-SMv6.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 pim sparse-mode nexthop
Mode User Exec and Privileged Exec
Example
awplus# show ipv6 pim sparse-mode nexthop
Figure 35-11: Example output from the show ipv6 pim sparse-mode nexthop
command
awplus#show ipv6 pim sparse-mode nexthop
Flags: N = New, R = RP, S = Source, U = Unreachable
Destination Type Nexthop Nexthop Nexthop Nexthop Metric Pref Refcnt
Num Addr Ifindex Name
_____________________________________________________________________________________
3ffe:10:10:5::153 .RS. 1 fe80::20e:cff:fe01:facc 2 30 110 1
Table 2: Parameters in output of the show ipv6 pim sparse-mode nexthop
command
Parameter Description
Destination The destination address for which PIM-SMv6 requires next hop
information.
Type The type of destination, as indicated by the Flags description. N =
New, R= RP, S = Source, U = Unreachable.
Nexthop Num The number of next hops to the destination. PIM-SMv6 always
uses only 1 next hop.
Nexthop Addr The address of the primary next hop gateway.
Nexthop
IfIndex
The interface on which the next hop gateway can be reached.
Nexthop Name The name of next hop interface.
Metric The metric of the route towards the destination.
Preference The preference of the route towards destination.
Refcnt Only used for debugging.
To Next Page
Loading...
Need help?
General
