Allied Telesis AlliedWare Plus - Show Ip Dhcp-Relay

C613-50100-01 REV C Command Reference for x930 Series 2748
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP) COMMANDS
SHOW
IP DHCP-RELAY
show ip dhcp-relay
Overview This command shows the configuration of the DHCP Relay Agent on each
interface.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip dhcp-relay [interface <interface-name>]
Syntax (VRF lite) show ip dhcp-relay [vrf <name>|global] [interface
<interface-name>]
Mode User Exec and Privileged Exec
Example To display the DHCP Relay Agent’s configuration on the interface vlan100, use
the command:
awplus# show ip dhcp-relay interface vlan100
Output Figure 55-9: Example output from the show ip dhcp-relay command
Parameter Description
<interface-name> Name of a specific interface. This displays the DHCP
configuration for the specified interface only.
vrf Apply this command to a VRF lite instance.
<vrf-name> The name of the VRF lite instance.
global The Global VRF lite Instance.
DHCP Relay Service is enabled

vlan100 is up, line protocol is up
Maximum hop count is 10
Insertion of Relay Agent Option is disabled
Checking of Relay Agent Option is disabled
The Remote Id string for Relay Agent Option is 0000.cd28.074c
Relay information policy is to append new relay agent 
information
List of servers : 192.168.1.200