C613-50100-01 REV C Command Reference for x930 Series 2053
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
802.1X COMMANDS
DOT
1X ACCOUNTING
dot1x accounting
Overview This command overrides the default RADIUS accounting method for IEEE
802.1X-based authentication on an interface by allowing you to apply a
user-defined named method list.
Use the no variant of this command to remove the named list from the interface
and apply the default method list.
Syntax
dot1x accounting {default|<list-name>}
no dot1x accounting
Default The default method list is applied to an interface by default.
Mode Interface Mode
Example To apply the named list 'vlan10_acct' on the vlan10 interface, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# dot1x accounting vlan10_acct
To remove the named list from the vlan10 interface and set the authentication
method back to default, use the commands:
awplus# configure terminal
awplus(config)# interface vlan10
awplus(config-if)# no dot1x accounting
Related
Commands
aaa accounting dot1x
Parameter Description
default Apply the default accounting method list
<list-name> Apply the user-defined named list
To Next Page
Loading...
