C613-50100-01 REV C Command Reference for x930 Series 1115
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
ROUTER
-ID (IPV6 OSPF)
router-id (IPv6 OSPF)
Overview Use this command to specify a router ID for the IPv6 OSPF process.
Use the no variant of this command to disable this function.
Syntax
router-id <router-id>
no router-id
Mode Router Configuration
Usage Configure each router with a unique router-id. In an IPv6 OSPF router process that
has active neighbors, a new router-id takes effect at the next reload or when you
restart OSPF manually.
Example The following example shows a specified router ID 0.0.4.5.
awplus# configure terminal
awplus(config)# router ipv6 ospf
awplus(config-router)# router-id 0.0.4.5
Related
Commands
show ipv6 ospf
Parameter Description
<router-id> Specifies the router ID in IPv4 address format.
To Next Page
Loading...
Need help?
General
