C613-50100-01 REV C Command Reference for x930 Series 256
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
NO
DEBUG ALL
no debug all
Overview This command disables the debugging facility for all features on your device. This
stops the device from generating any diagnostic debugging messages.
The debugging facility is disabled by default.
Syntax
no debug all [bgp|ipv6|dot1x|nsm|ospf|vrrp]
Mode Global Configuration and Privileged Exec
Example To disable debugging for all features, use the command:
awplus# no debug all
To disable all bgp debugging, use the command:
awplus# no debug all bgp
To disable all 802.1X debugging, use the command:
awplus# no debug all dot1x
To disable all IPv6 debugging, use the command:
awplus# no debug all ipv6
To disable all NSM debugging, use the command:
awplus# no debug all nsm
To disable all OSPF debugging, use the command:
awplus# no debug all ospf
To disable all VRRP debugging, use the command:
awplus# no debug all vrrp
Related
Commands
undebug all
Parameter Description
bgp Turns off all debugging for BGP (Border Gateway Protocol).
dot1x Turns off all debugging for IEEE 802.1X port-based network access-
control.
ipv6 Turns off all debugging for IPv6 (Internet Protocol version 6).
nsm Turns off all debugging for the NSM (Network Services Module).
ospf Turns off all debugging for OSPF (Open Path Shortest First).
vrrp Turns off all debugging for VRRP (Virtual Router Redundancy Protocol).
To Next Page
Loading...
Need help?
General
