25
C613-50100-01 REV C Command Reference for x930 Series 922
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIPng for IPv6
Commands
Introduction
Overview This chapter contains RIPng commands. RIPng (Routing Information Protocol next
generation) is an extension of RIPv2 to support IPv6. RFC 2080 specifies RIPng. The
differences between RIPv2 and RIPng are:
• RIPng does not support RIP updates authentication
• RIPng does not allow the attachment of arbitrary tags to routes
• RIPng requires the encoding of the next-hop for a set of routes
For more information, see the RIPng Feature Overview and Configuration Guide.
Command List •“aggregate-address (IPv6 RIPng)” on page 924
•“clear ipv6 rip route” on page 925
•“debug ipv6 rip” on page 926
•“default-information originate (IPv6 RIPng)” on page 927
•“default-metric (IPv6 RIPng)” on page 928
•“distribute-list (IPv6 RIPng)” on page 929
•“ipv6 rip metric-offset” on page 930
•“ipv6 rip split-horizon” on page 932
•“ipv6 router rip” on page 933
•“neighbor (IPv6 RIPng)” on page 934
•“offset-list (IPv6 RIPng)” on page 935
•“passive-interface (IPv6 RIPng)” on page 936
•“recv-buffer-size (IPv6 RIPng)” on page 937
•“redistribute (IPv6 RIPng)” on page 938
•“route (IPv6 RIPng)” on page 939
To Next Page
Loading...
Need help?
General
