Allied Telesis AlliedWare Plus - Neighbor Route-Server-Client (BGP Only)

C613-50100-01 REV C Command Reference for x930 Series 1331
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
NEIGHBOR
ROUTE-SERVER-CLIENT (BGP ONLY)
neighbor route-server-client (BGP only)
Overview Use this command to specify the peer as route server client.
Use the no variant of this command to disable this function.
Syntax
neighbor <neighborid> route-server-client
no neighbor <neighborid> route-server-client
Mode Router Configuration
Examples
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# neighbor 10.10.0.72 route-server-client
awplus# configure terminal
awplus(config)# router bgp 10
awplus(config-router)# no neighbor 10.10.0.72
route-server-client
Parameter Description
<neighborid> {<ip-address>|<peer-group>}
<ip-address> The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
<peer-group> Enter the name of an existing peer-group. For
information on how to create peer groups,
refer to the neighbor peer-group (add a
neighbor) command, and neighbor route-map
command. When this parameter is used with
this command, the command applies on all
peers in the specified group.