C613-50100-01 REV C Command Reference for x930 Series 2194
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AUTHENTICATION COMMANDS
SHOW
AUTH STATISTICS INTERFACE
show auth statistics interface
Overview This command shows the authentication statistics for the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
Syntax
show auth statistics interface <interface-list>
Mode Privileged Exec
Example To display Web-Authentication statistics for port1.0.4, enter the command:
awplus# show auth statistics interface port1.0.4
Related
Commands
show dot1x interface
Parameter Description
<interface-list> The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
To Next Page
Loading...
