C613-50100-01 REV C Command Reference for x930 Series 783
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
DOMAIN NAME SERVICE (DNS) COMMANDS
IP
DNS FORWARDING
ip dns forwarding
Overview Use this command to enable DNS Relay, the forwarding of incoming DNS queries
for IP hostname-to-address translation.
Use the no variant of this command to disable the forwarding of incoming DNS
queries for IP hostname-to-address translation.
Syntax
ip dns forwarding
no ip dns forwarding
Default The forwarding of incoming DNS query packets is disabled by default.
Mode Global Configuration
Usage DNS Relay requires that IP domain lookup is enabled. IP domain lookup is enabled
by default, but if it has been disabled, you can re-enable it by using the command
ip domain-lookup.
See the IP Feature Overview and Configuration Guide for more information about
DNS Relay. See the ip dns forwarding dead-time command used with this
command.
NOTE: When running VRF lite, the DNS Relay functions will apply separately within
each VRF lite Instance.
Examples To enable the forwarding of incoming DNS query packets, use the commands:
awplus# configure terminal
awplus(config)# ip dns forwarding
To disable the forwarding of incoming DNS query packets, use the commands:
awplus# configure terminal
awplus(config)# no ip dns forwarding
Related
Commands
clear ip dns forwarding cache
debug ip dns forwarding
ip dns forwarding cache
ip dns forwarding dead-time
ip dns forwarding retry
ip dns forwarding source-interface
ip dns forwarding timeout
ip name-server
show ip dns forwarding
show ip dns forwarding cache
show ip dns forwarding server
To Next Page
Loading...
Need help?
General
