C613-50100-01 REV C Command Reference for x930 Series 1809
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-SMV6 COMMANDS
SHOW
IPV6 PIM SPARSE-MODE INTERFACE
show ipv6 pim sparse-mode interface
Overview Use this command to show PIM-SMv6 interface information. Note that you can
specify an individual VLAN interface with the optional parameter. Alternatively,
you can display PIM-SMv6 interface information for all interfaces if you omit the
optional interface parameter.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ipv6 pim sparse-mode interface
Mode User Exec and Privileged Exec
Examples To display information about all PIM-SMv6 interfaces, use the command:
awplus# show ipv6 pim sparse-mode interface
awplus#show ipv6 pim sparse-mode interface
Interface VIFindex Ver/ Nbr DR
Mode Count Priority
vlan2 0 v2/S 2 1
Address : fe80::207:e9ff:fe02:81d
Global Address: 3ffe:192:168:1::53
DR : fe80::20e:cff:fe01:facc
vlan3 2 v2/S 2 1
Address : fe80::207:e9ff:fe02:21a2
Global Address: 3ffe:192:168:10::53
DR : this system
Table 1: Parameters in the output from the show ipv6 pim sparse-mode
interface command
Parameters Description
Address Primary PIM-SMv6 address.
Interface Name of the PIM-SMv6 interface.
VIF Index The Virtual Interface index of the VLAN.
Ver/Mode PIMv6 version/Sparse mode.
Nbr Count Neighbor count of the PIM-SMv6 interface.
DR Priority Designated Router priority.
DR The IPv6 address of the Designated Router.