Allied Telesis AlliedWare Plus - Ipv6 Ospf Display Route Single-Line

C613-50100-01 REV C Command Reference for x930 Series 1096
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPFV3 FOR IPV6 COMMANDS
IPV
6 OSPF DISPLAY ROUTE SINGLE-LINE
ipv6 ospf display route single-line
Overview Use this command to change the result of the show ipv6 route command to
display each route entry on a single line.
Syntax
ipv6 ospf display route single-line
no ipv6 ospf display route single-line
Mode Global Configuration
Example To display each route entry on a single line.
awplus# configure terminal
awplus(config)# ipv6 ospf display route single-line
Related
Commands
show ipv6 ospf route