EasyManuals Logo

Allied Telesis AlliedWare Plus User Manual

Allied Telesis AlliedWare Plus
3082 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1159 background imageLoading...
Page #1159 background image
C613-50100-01 REV C Command Reference for x930 Series 1159
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
BGP AND BGP4+ COMMANDS
AGGREGATE
-ADDRESS
aggregate-address
Overview This command adds an aggregate route that can be advertised to BGP or BGP4+
neighbors. This command creates an aggregate entry in the BGP or BGP4+ routing
table if the device learns, by any means, any routes that are within the range
configured by the aggregate address/mask.
When this command is used with the summary-only option, the more-specific
routes of the aggregate are suppressed to all neighbors. Use the neighbor
unsuppress-map command instead to selectively leak more-specific routes to a
particular neighbor.
The no variant of this command removes the aggregate configured by the
aggregate-address command.
Syntax [BGP]
aggregate-address <ip-addr/m> {summary-only|as-set}
no aggregate-address <ip-addr/m> {summary-only|as-set}
Syntax [BGP4+] aggregate-address <ipv6-addr/prefix-length>
{summary-only|as-set}
no aggregate-address <ipv6-addr/prefix-length>
{summary-only|as-set}
Mode [BGP] Router Configuration or IPv4 Address Family Configuration
Mode [BGP4+] IPv6 Address Family Configuration
Usage [BGP] If the summary-only parameter is specified, then only the aggregate
address/mask will be advertised, and none of the component addresses that fall
within the range of the aggregate address/mask. For example, if you configure:
Parameter Description
<ip-addr/m> Specifies the aggregate IPv4 address and mask.
<ipv6-addr/
prefix-length>
Specifies the aggregate IPv6 address. The IPv6 address uses
the format X:X::X:X/Prefix-Length. The prefix-length is usually
set between 0 and 64.
summary-only Filters more specific routes from updates. Only the aggregate
address/mask will be advertised, and none of the component
addresses that fall within the range of the aggregate address/
mask.
as-set Generates AS set path information. The AS-path advertised
with the aggregate is an unordered list of all the AS-numbers
that appear in any of the AS-paths of the component routes,
with each AS-number appearing just once in the list.

Table of Contents

Other manuals for Allied Telesis AlliedWare Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AlliedWare Plus and is the answer not in the manual?

Allied Telesis AlliedWare Plus Specifications

General IconGeneral
BrandAllied Telesis
ModelAlliedWare Plus
CategorySwitch
LanguageEnglish

Related product manuals