C613-50100-01 REV C Command Reference for x930 Series 1923
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST STANDARD NAMED FILTER)
(access-list standard named filter)
Overview This ACL filter adds a source IP address filter entry to a current named standard
access-list. If the sequence number is specified, the new filter entry is inserted at
the specified location. Otherwise, the new entry is added at the end of the
access-list.
The no variant of this command removes a source IP address filter entry from the
current named standard access-list. You can specify the source IP address filter
entry for removal by entering either its sequence number (e.g. no 10), or by
entering its source IP address filter profile without specifying its sequence number.
Note that the sequence number can be found by running the show access-list (IPv4
Software ACLs) command.
Syntax
[<sequence-number>] {deny|permit} {<source> [exact-match]|any}
no {deny|permit} {<source> [exact-match]|any}
no <sequence-number>
Mode IPv4 Standard ACL Configuration
Default Any traffic controlled by a software ACL that does not explicitly match a filter is
denied.
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the
selected access control list.
deny Access-list rejects packets of the source filtering
specified.
permit Access-list allows packets of the source filtering
specified
<source> The source address of the packets. You can specify
either a subnet or all sources. The following are the
valid formats for specifying the source:
<ip-addr>/
<prefix>
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any
destination IP address within
the specified subnet.
<ip-addr> An IPv4 address in a.b.c.d
format.
exact-match Specify an exact IP prefix to match on.
any Matches any source IP address.
To Next Page
Loading...
Need help?
General
