C613-50100-01 REV C Command Reference for x930 Series 3042
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PING-POLLING COMMANDS
CRITICAL
-INTERVAL
critical-interval
Overview This command specifies the time period in seconds between pings when the
polling instance has not received a reply to at least one ping, and when the device
is unreachable.
This command enables the device to quickly observe changes in state, and should
be set to a much lower value than the normal-interval command.
The no variant of this command sets the critical interval to the default of one
second.
Syntax
critical-interval <1-65536>
no critical-interval
Default The default is 1 second.
Mode Ping-Polling Configuration
Examples To set the critical interval to 2 seconds for the ping-polling instance 99, use the
commands:
awplus# configure terminal
awplus(config)# ping-poll 99
awplus(config-ping-poll)# critical-interval 2
To reset the critical interval to the default of one second for the ping-polling
instance 99, use the commands:
awplus# configure terminal
awplus(config)# ping-poll 99
awplus(config-ping-poll)# no critical-interval
Related
Commands
fail-count
normal-interval
sample-size
show ping-poll
timeout (ping polling)
up-count
Parameter Description
<1-65536> Time in seconds between pings, when the device has failed to
a ping, or the device is unreachable.
To Next Page
Loading...
